Owner`s manual

CAUSE: Port selection.

SOLUTION: Be sure host device is connected to the

host port (Port 1) on the Model 24H.

CAUSE: Software.

SOLUTION: Use dumb terminal or a computer

running a terminal emulation program (i.e., TERM

supplied by BayTech, or another communications

package).

CAUSE: Bad serial port on host computer.

SOLUTION: Try a different serial port or host device.

PROBLEM: GARBAGE DATA

SYMPTOM: MISSING CHARACTERS

CAUSE: No data flow control due to incorrect cable

type.

SOLUTION: Check hardware handshaking lines in the

cable. The CTS is the input flow control line and

DTR is the output flow control line. Determine

which flow control signals are defined as input and

output for your equipment. Connect the CTS line

to the signal defined as output and DTR to the

signal defined as input. If using XON/XOFF

handshaking, verify that both Tx and Rx are

connected in the cable. Also verify that

XON/XOFF handshaking is enabled on the Model

24H and that your equipment supports XON/XOFF.

CAUSE: Cable length.

SOLUTION: BayTech will guarantee EIA-232 serial

data transmission up to 150 feet at 9600 baud. If

your cable exceeds this length, either shorten your

cable length or reduce the baud rate.