Owner`s manual

37
" 
By responding to the Enter Request: message at the end of the
configuration menu (see Section 6.1 ) with "7" (Set Data Block Length),
you may change the data block length of Mode of Operation 6. The
Model 24H will respond with:
Current Block Length is...................31
Enter Block Length (1 to 250)............:
Enter the block length that you desire, followed by <ENTER>. For
example, if you enter "100" and <ENTER>, the data exchange system
will respond with:
Current Block Length is..................100
Save Changes Permanently? (Y/N):
If you answer "Y" (yes), the new block length will be saved in
non-volatile memory, and the Model 24H will subsequently power-up at
that new length. If you answer "N" (no), the new data block length will
be stored in RAM and will be lost upon next power-up. The Model 24H
will now return to the main configuration menu.
# 
By responding to the Enter Request: message at the end of the main
configuration menu (see Section 6.1 ) with "8" (Set Mode of Operation),
you may change the current mode of operation. The Model 24H will
respond with:
MODE OF OPERATION
Full Duplex Communication...................1
All Messages from All Ports.................2
Single Message from All Ports...............3
All Messages from Selected Port.............4
Single Message from Selected Port...........5
Time Division Multiplexing..................6
Exit........................................X
Current Mode of Operation is............... 1
Enter Mode of Operation :
You may now enter the mode of operation that you wish. The Model
24H will now return to the main configuration menu.