Owner`s manual

33
The Model 24H will then respond with the following prompt:
Enter Parallel Port Number (? = Help, ENTER = Exit) :
Enter the number of any other serial port that you wish to reconfigure.
If you do not wish to reconfigure any other serial port, type <ENTER>
and the Model 24H will return the main configuration menu (see
Section 6.1 ). The Model 24H will exit from this menu when the
operator strikes the Enter key. The unit will also exit when the operator
enters the character "0" and then strikes the Enter key. The Model 24H
will now return to the main configuration menu.
 
By responding to the Enter Request: message at the end of the main
configuration menu (see Section 6.1 ) with "4" (Change Port Logical
Name), you may enter a logical or identifying name for each device
connected to the Model 24H. These logical names appear in the
configuration menus only. The Model 24H will respond with:
Enter Port Number (? = Help, ENTER = Exit) :
Type the number of the desired port followed by <ENTER>. If you type
"?", the Model 24H will respond with a menu showing the current logical
names of all ports. For example, if you type "7" and <ENTER> for Port
7, the Model 24H will respond with :
+------+------------------+-------+------+------+------+------+------+
| Port | Logical Name | Baud | Word | Stop |Parity| Xon / Xoff |
| | | Rate | Size | Bits | | Xmit | Recv |
+------+------------------+-------+------+------+------+------+------+
| 7 | Device D | 38400 | 8 | 1 | None | On | On |
+------+------------------+-------+------+------+------+------+------+
Enter Logical Name (Max. 16 characters)
or ENTER for no change ....................: