Owner`s manual

Enter "8" for 38400 baud rate, and the Model 24H will respond with the

reconfigured status of the port, the option menu, and the prompt:

+------+------------------+-------+------+------+------+------+------+

+------+------------------+-------+------+------+------+------+------+

| 7 | Device D | 38400 | 8 | 1 | None | Off | Off |

+------+------------------+-------+------+------+------+------+------+

Exit/Save......1 Set Stop Bits.....4

Set Baud Rate..2 Set Parity........5

Set Word Size..3 Set Xon/Xoff......6

Enter Request :

You may now select other options from the menu to reconfigure Port 7.

For example, to set XON/XOFF, type "6" (Set Xon/Xoff) in response to

the prompt. Note that Output Flow Control and Input Flow Control are

set separately for each port. The Model 24H will respond with:

Output Flow Control (Xmit) - Xon/Xoff is ( Off )

Stop/Restart Output Upon Receiving of Xoff/Xon ? (Y/N) :

You should then enter "Y" to enable XON/XOFF on transmit, "N" to

disable XON/XOFF on transmit. For example, if you entered "Y", the

Model 24H will respond with:

Input Flow Control (Recv) - Xon/Xoff is ( Off )

Xoff/Xon sent based on Buffer - Full/Empty condition ? (Y/N) :

You should then enter "Y" to enable XON/XOFF on receive, "N" to

disable XON/XOFF on receive. For example, if you enter "N", the

Model 24H will respond with the reconfigured status of the port, the

option menu and the prompt.

+------+------------------+-------+------+------+------+------+------+

+------+------------------+-------+------+------+------+------+------+

| 7 | Device D | 38400 | 8 | 1 | None | On | Off |

+------+------------------+-------+------+------+------+------+------+

Exit/Save......1 Set Stop Bits.....4

Set Baud Rate..2 Set Parity........5

Set Word Size..3 Set Xon/Xoff......6

Enter Request :