Owner`s manual





By responding to the

Enter Request:

message at the end of the main

configuration menu (see

Section 6.1

) with "2" (Set Serial Port

Configuration), you may change the serial configuration of each port

(i.e. baud rate, word size, stop bits, parity, and XON/XOFF

handshaking). Each port is configured individually. This allows the

Model 24H to translate between devices of different configurations

without the need to reconfigure the devices. The Model 24H will

respond with:

Enter Serial Port Number (? = Help, ENTER = Exit) :

Type the number of the desired serial port followed by <ENTER>. If

you type "?", the Model 24H will respond with a menu showing the

current configuration status of all serial ports. For example, if you type

"7" and <ENTER>, the Model 24H will respond with the current status

of Port 7 and a menu of the available options.

+------+------------------+-------+------+------+------+------+------+

+------+------------------+-------+------+------+------+------+------+

| 7 | Device D | 9600 | 8 | 1 | None | Off | Off |

+------+------------------+-------+------+------+------+------+------+

Exit/Save......1 Set Stop Bits.....4

Set Baud Rate..2 Set Parity........5

Set Word Size..3 Set Xon/Xoff......6

Enter Request :

You may now reconfigure Port 7 by selecting the appropriate option (1-

6) from the menu. For example, to change the baud rate to 38400

baud, type "2" (Set baud rate). The Model 24H will respond with:

1 For 300

2 For 600

3 For 1200

4 For 2400

5 For 4800

6 For 9600

7 For 19200

8 For 38400

Enter Request :