Owner`s manual

28
OPERATION PROTOCOL
+------+-------------------------+-----------+------+------+
| Mode | Host port Control Code | Receive | Rcv. | Rcv. |
| of +------------+------------+ Port | Term |Block |
| Opern| XMIT data | RCV data | I.D. | Chr. |Length|
+------+------------+------------+-----------+------+------+
| 1 | $SELECTm,p | $SELECTm,p | ---N/A--- | -N/A | -N/A |
| 2 | $SELECTm,p | ----N/A--- | m,p | 0DH | -N/A |
| 3 | $SELECTm,p | $SELECTS | m,p | 0DH | -N/A |
| 4 | $SELECTm,p | $SELECTSm,p| m,p | 0DH | -N/A |
| 5 | $SELECTm,p | $SELECTSm,p| m,p | 0DH | -N/A |
| 6 | $SELECTm,p | ----N/A--- | $SELECTm,p| -N/A | 32 |
+------+------------+------------+-----------+------+------+
H = Hexadecimal , S = ASCII 53H , ^ = ASCII 00H to 1FH
m,p - Module, Port Number and CR or LF
Strike any Key to Continue, or X to Exit
Status.....................................1
Set Serial Port Configuration..............2
Change Port Logical Name...................3
Program Port Select Code...................4
Change Message Terminate Character.........5
Change Data Block Length...................6
Change Mode of Operation...................7
Exit.......................................X
Enter Request :
You may now make whatever changes are necessary by responding to
the above menu. The Exit function will return you to the Operations
Mode.