Owner`s manual

13
 
This is a single character that indicates a completed message to the
Model 24H in Modes of Operation 2, 3, 4 and 5. Data is held in the
buffer of the Model 24H until the terminating character is received from
the host device which defines a complete message. The complete
message is eventually sent to the host device depending on which
mode of message multiplexing the Model 24H is in. The message
terminating character may be programmed to be any two-digit
hexadecimal character from 00 Hex to 7F Hex.
The factory default message terminating character is Carriage
Return (0D Hex).
 
The data block length is the maximum number of characters per data
block transmitted out of the host port while operating in Mode 6 (time
division multiplexing). You may select a data block length of 8 to 240
characters.
Factory default is 32 characters.