Owner`s manual
6
BayTech provides utility software for DOS compatible PCs to assist you
in configuring the Model 24H. This diskette contains the following
programs: REMCONFG.COD, SMODE.EXE, TERM.EXE, AND
README.RDM. The Model 24H does not utilize the REMCONFG.COD
file. TERM.EXE is a terminal emulation program used to configure the
various features of the unit. SMODE.EXE is a program used to
configure COM ports of DOS compatible machines to operate at
speeds faster than 9600 bps.
IMPORTANT: Copy the BayTech original diskette onto a blank diskette
and store the original in a safe place. Read your operating systems
manual for copying instructions.
Please review the README.RDM file to obtain instructions for
TERM.EXE and SMODE.EXE. To view the README.RDM file on your
screen, first insert the diskette into your PC's disk drive and then enter
the command TYPE README.RDM from your disk drive prompt. To
print this file, enter the command COPY README LPT1: from your
disk drive prompt.
The standard Model 24H requires 115VAC, 50/60 Hz. power and
comes with a three-prong power cord. Do not attempt to operate the
unit with a two-prong socket or adapter. 230 VAC, 50/60 Hz. is
optional.
All Model 24H models power-up when you depress the power switch,
located on the back of the unit, to "ON". The green power LED on the
front panel will illuminate when power is applied.
CAUTION: Do not attempt to make any internal changes. Any
upgrades to EPROM, memory, or module installation must be
performed by an authorized service technician or by BayTech. Please
contact BayTech at 1-800-523-2702.