User manual

G.lite : G.992.2 Annex A
G.dmt : G.992.1 Annex A
T1.413 : T1.413 issue #2
ADSL2 : G.992.3 Annex A
ADSL2+ : G.992.5 Annex A
AnnexL Option
Enable/Disable ADSL2/ADSL2+ Annex L capability.
AnnexM Option
Enable/Disable ADSL2/ADSL2+ Annex M capability.
ADSL Capability
“Bit
-
swap Enable” :
Enable/Disable bit
-
swap capability.
“SRA Enable” : Enable/Disable SRA (seamless rate adaptation) capability.
Function buttons in this page:
Apply Changes
Click to save the setting to the configuration and the modem will be retrained.
13. Services
There are thirteen sub-menus for Services: [DHCP Config], [DNS], [Acess Control List], [NAT/NAPT],
[Priority Queue], [QoS], [Traffic Shaping], [MAC Filtering], [DMZ], [URL Block], [DOS Setting], [IGMP
Proxy] and [RIP].
13.1. DHCP Config
You can configure your network and DSL device to use the Dynamic Host Configuration Protocol
(DHCP). This page provides DHCP instructions for implementing it on your network by selecting the
role of DHCP protocol that this device wants to play. There are two different DHCP roles that this
device can act as: DHCP Serve and DHCP Relay. When acting as DHCP server, you can setup the server
parameters at the DHCP Server page; while acting as DHCP Relay, you can setup the relay at the DHCP
Relay page.
13.1.1. DHCP Mode
By default, the device is configured as a DHCP server, with a predefined IP address pool of 192.168.1.2
through 192.168.1.254 (subnet mask 255.255.255.0).