User manual

Fields in this page:
Field
Description
Disable WPS
Check to disable the Wi
-
Fi protected Setup.
WPS Status
When AP’s settings are factory default (out of box), it is set to open security
and un-configured state. “WPS Status” will display it as “UnConfigured”. If it
already shows “Configured”, some registrars such as Vista WCN will not
configure AP. Users will need to go to the “Backup/Restore” page and click
“Reset” to reload factory default settings.
Self
-
PIN Number
“Self
-
PIN Number” is
AP’s PIN. Whenever users want to change AP’s PIN,
they could click “Regenerate PIN” and then click “Apply Changes”.
Moreover, if users want to make their own PIN, they could enter four-digit
PIN without checksum and then click “Apply Changes”. However, this would
not be recommended since the registrar side needs to be supported with
four-digit PIN.
Push Button
Configuration
Clicking this button will invoke the PBC method of WPS. It is only used when
AP acts as a registrar.
Client PIN Number
It is only use
d when users want their station to join AP’s network. The
length of PIN is limited to four or eight numeric digits. If users enter eight-
digit PIN with checksum error, there will be a warning message popping up.
If users insist on this PIN, AP will take it.
Function buttons in this page:
Regenerate PIN