Instructions / Assembly

22
TROUBLE SHOOTING GUIDE
SYMPTOM
Burner will not light
and burner tube is clean
Not enough gas flow from
propane tank
Open propane tank valve all
the way
CAUSE POSSIBLE SOLUTION
Low gas level in propane tank,
or tank is empty
Check gas level in propane tank,
re-fill or exchange tank
Faulty regulator hose assembly Contact 1-800-864-6194;
Model M5HPR-30
Hissing or gurgling sounds
coming through gas train
from tank to burner
Damaged hose Perform soapy water test to check
for cracks in hose.
See pages 12-13; Model M5HPR-30
Gas leak Perform soapy water test to check
all connections - See pages 12-13
Flame has gone out
Low gas level in propane tank,
or tank is empty
Check gas level in propane tank
Too much wind Check wind direction and set
cooker away from windy areas
Blockage in burner tube Clean and check burner tube for
spiders, insect nests and debris
Cooker lights but the flame
remains very small
Repeated from page 21
Rapid gas flow from propane
tank activates EXCESS FLOW
safety device
Repeat lighting instructions and
be certain to S-L-O-W-L-Y open
cylinder valve one full turn, then
S-L-O-W-L-Y open regulator valve
to light cooker
Cooker will not light
Repeated from page 21
Orifice Hole in Jet Tube is not
facing straight up
Using a wrench, turn brass cap
until orifice hole is facing up
Do not use this appliance if gas
leaks cannot be stopped and
corrected.
Orifice hole is blocked Using a wire, insert into orifice
hole to remove blockage debris