Instructions / Assembly

O
N
-
C
L
O
C
K
W
I
S
E
16
Turn COUNTER-CLOCKWISE
to Disconnect
O
F
F
-
C
L
O
C
K
W
I
S
E
Turn OFF
LP Cylinder.
Close Fully
1
Disconnect
Regulator
3
Turn OFF
Regulator.
Close Fully
2
O
F
F
-
C
O
U
N
T
E
R
-
C
L
O
C
K
W
I
S
E
BURNER FLAME CHECK
When lighting for the first time, you will smell paint burning at the top of the cooker for a few minutes...
This is normal.
The regulator valve controls flame intensity. Practicing adjusting
flame height up and down. You will notice that this cooker
emits a loud JET sound, hence the name Jet Cooker.
HOW TO REIGNITE BURNER
If burner flame does NOT ignite immediately, or is accidentally
extinguished, turn LP Gas Cylinder Valve clockwise to OFF.
Then turn regulator valve clockwise to OFF position.
Wait 5 minutes for gas to evacuate before re-lighting, then repeat
steps 1-7 to re-light. Always use caution when re-lighting as cooker frame
and cooking vessel will be hot.
If the cooker does not light within the first few attempts, there is a problem with the gas supply.
Turn off the gas at the cylinder and regulator. DO NOT attempt to operate the cooker until the problem
is found and corrected. Refer to Troubleshooting on Pages 21 - 22.
WARNING
In bright sunlight the flame may appear invisible. DO NOT lean over the cooker during use.
DO NOT wear loose clothing or allow long hair to hang freely while lighting or using the cooker.
FOR YOUR SAFETY:
TURNING OFF JET COOKER AND DISCONNECTING HOSE
NOTE: Turn off LP gas cylinder valve first to prevent gas from being left in the regulator hose system
under pressure.
1. Turn OFF the LP gas cylinder valve clockwise until it stops.
2. Turn regulator valve to the OFF position, counter-clockwise until it stops.
3. To disconnect Regulator Hose Assembly, turn the large coupling nut counter-clockwise by hand.
ADJUST Regulator Control Knob
for Flame Height
WARNING
The LP gas cylinder valve should always be in the OFF or closed position when the cooker is not
in use.