Instructions / Assembly

• Do not stand with head, body or arms over the appliance when lighting. Loose hair

and clothing can catch re.

• Do not light burner at air intake.

LIGHTING INSTRUCTIONS

Follow these instructions for safe and proper lighting and re-lighting of the appliance.

Do not attempt to light this appliance without rst folllowing the instructions in this

manual for proper assembly, placement, and testing.

CAUTION

If the appliance does not light after 2 or 3 attempts, turn OFF gas supply and

regulator. Refer to Trouble-Shooting Tips and DO NOT attempt to operate the

appliance until the problem is resolved.

CAUTION

1. Make sure the LP cylinder valve is in the full OFF position. Check this by

rotating the valve in the CLOSE direction until it stops.

2. Make sure the HVR brass valve is in the full OFF position. Check this by ro-

tating the valve in the CLOSE direction until it stops. NOTE: If the brass valve is

left in the ON position, the Gas Flow Limiting Device will activate.

3. Turn on the fuel supply by S-L-O-W-L-Y rotating the LP cylinder valve one full

turn in the OPEN direction. NOTE: To prevent activating the Gas Flow Limiting

Device, always open the LP cylinder valve slowly.

4. Position a ﬁreplace match or long lighter over the burner, then S-L-O-W-L-Y

turn the HVR brass valve OPEN until you hear gass HISSING from the burner.

The burner should light immediately.

5. If the ﬂame fails to light within 3-5 seconds, turn OFF the gas ﬂow by

rotating the HVR brass valve in the CLOSE direction until it stops. Allow gas to

evacuate/dissipate before repeating Steps 3 & 4.

WARNING