Instructions / Assembly

10
CONNECTING REGULATOR HOSE ASSEMBLY TO COOKER
The Regulator Hose Assembly is a pre-assembled unit. Do not take apar
t. Simply connect the regulator hose assembly to the
LP gas cylinder and to the cooker. An adjustable wrench is needed when attaching the hose to the Jet Tube. Visually inspect
the regulator hose assembly prior to each use. If there is evidence of abrasion, wear, cuts or leaks, the hose must be replaced
prior to the appliance being put into operation.
Attach hose connector to Jet Tube as shown below.
WARNING
Insure the cylinder valve is CLOSED (valve turned clockwise) prior to connecting the LP gas cylinder to your
cooker. T
urn brass valve on the regulator clockwise to properly close the flow of gas. Read and follow all
instructions and warnings on the supply hose safety tags. Read and follow all warnings in this manual
concerning the safe use of LP gas cylinders and the regulator hose assembly, before connecting cylinder to
cooker. Read and follow all warnings on the LP gas cylinder.
Turn Coupling Nut
CLOCKWISE
to Attach
Hand Tighten!
Turn Brass Valve
CLOCKWISE
to OFF position
Upright
position
1. Check that cylinder is upright and the valve is closed by tur
ning
the knob clockwise.
2. Remove the protective safety cap from the cylinder valve and the
Type-1 Coupling Nut on the regulator
3. Insert the nipple of the large coupling nut into cylinder valve outlet.
Insure that the coupling nut is centered properly.
4. Turn the large coupling nut clockwise by hand and tighten
to a full stop. Take care not to cross thread the coupling nut
onto the cylinder valve. Do not use tools to tighten connection.
NOTE: If you are unable to make the connection,
repeat steps 3 and 4.
5. Check that the hose does not contain kinks, does not come into contact with sharp edges, and does not contact surfaces
that may become hot during use.
6. Leak check all fittings before lighting cooker. See section on "Gas Leak Test Instructions" on next page.
CONNECTING REGULATOR HOSE ASSEMBLY TO LP GAS CYLINDER
Turn CLOCKWISE
Wrench T
ighten
Assembled
View