Instructions / Assembly

The pressure regulator and hose assembly supplied with your gas cooker is only designed to work with an

LP gas supply cylinder

• DO NOT attempt to connect it to any other fuel supply source such as a natural gas line.

• DO NOT use any other pressure regulator/hose assembly than the one supplied with your cooker.

• DO NOT attempt to adjust or repair the regulator. Contact Bayou Classic customer service for a

replacement hose.

• Never use your cooker without leak testing all gas connections, regulator hose assembly and weld seams

on propane tank. See the section on "Gas Leak Testing" in this manual for proper procedures.

Your cooker is equipped with a Type-1 connection device

with the following features:

1. The system will not allow gas flow from the cylinder until a

positive connection

to the cylinder valve has been made.

NOTE:

The cylinder valve must be turned off clockwise before any

connection is made or removed.

2. A GAS FLOW LIMITING DEVICE, when activated, restricts the

flow of gas to 10 cubic feet per hour.

NOTE: the flow limiting device is a safety feature that can be activated

when attempting to light cooker. If this occurs, refer to Trouble Shooting

on pages 16 - 17 for proper remedy.

3. After cooking is finished and cylinder valve is turned off; turn the

Regulator Control Knob counter-clockwise to the OFF position.

This will reduce possibility of activating the Gas Flow Limiting Device the next time you light the cooker.

DANGER

REGULATOR HOSE ASSEMBLY

• Use only the regulator hose assembly that is supplied with this appliance.

Inspect the hose before each use of the cooker. If there is evidence of abrasion,

wear

, cuts or leaks, the hose must be replaced prior to the cooker being put into

operation. Replace regulator hose assembly at least every two years.

This part can be purchased by contacting www.thebayou.com.

• Refer to instructions for connecting regulator hose assembly to LP gas cylinder and burner in this manual.

• The valve on regulator hose assembly controls flame intensity only. It is not an ON/OFF valve. Use LP Cylinder Valve

to turn gas ON and OFF.

TYPE-1

Connector

Coupling Nut

Regulator

alve

For connection to

LP Gas Cylinder

Brass Orifice

Connector

For connection

to Burner