Instructions / Assembly

HOSE & REGULATOR
The Hose Valve Regulator (HVR) supplied with this appliance is an independently CSA certified product. It is
designed to connect the appliance to a 9.1 Kg/20 lbs LP Cylinder. Read and follow all instructions and warnings
on the supply hose safety tags. Clean and inspect the HVR before each use of the appliance. If there is evidence of
abrasion, wear, cuts or leaks, the HVR must be replaced prior to the appliance being put into operation. No matter
the physical appearance, replace the HVR assembly every two years. Replace only with Model #M5HPR-TMR.
Adjustable Control
Knob
0-5 PSI Adjustable
Regulator
Gas Flow
TImer
Type-1
Connector
Wire Hook
90 cm/36-in
High Pressure
Hose
Male Connector
(#59 Orifice)
WARNING
• Do not attempt to disassemble, alter, or repair any part of the hose and regulator
assembly. Approved replacement parts can be obtained from Barbour International, Inc.
• Always disconnect the HVR from the LP Cylinder to test the Gas Flow Timer.
9
This HVR is equipped with a Gas Flow Timer. It is designed to shut off the flow of gas after a pre-set ime period unless
manually reset by the user. Follow the instructions in this manual for proper use of this product:
• The Gas Flow Timer requires two “AAA” alkaline batteries to operate (batteries not included).
• Testing the Gas Flow Timer:
A. Test the Timer before attaching the Regulator to the LP Cylinder.
B. Press the black POWER button (both lights will blink once).
C. Press the red START button (green Gas Flow light will remain on)
D. Allow the timer to complete the entire 15-minute cycle; note the approximate times for each stage.
E. When Gas Flow light turns off, the test is complete. If operating correctly, proceed with using the HVR.
NOTE: Test the operation of the Gas Flow Timer whenever changing the batteries, or if they have been left
in the device.
• Operational Cycle: (all times are approximations)
1-10 minutes, green Gas Flow light will remain on signaling gas can flow through the regulator to the hose.
10-13 minutes, green Gas Flow light will begin to blink slowly.
13-15 minutes, green Gas Flow light will blink rapidly warning that timed cycle is near completion.
15 minutes, operational cycle ends.
• Resetting the Timer: The timer can be RESET throughout the cooking process by pushing the red START button.
This will begin a new 15-minute operational cycle, and the gas will not shut off.
• Expired Cycle: When the timed cycle expires, gas flow will cease and the flame will extinguish. If more time is
needed to complete cooking, repeat lighting procedure outlined in this manual.
S
T
A
R
T
C
O
M
I
E
N
Z
O
D
E
B
U
T
Low Battery
Light (red)
Gas Flow
Light (green)
Power Button
Start (Reset)
Button
• Always disconnect regulator from the LP Cylinder before installing or removing the batteries.
• Always confirm both LP Cylinder Valve and Regulator Knob are turned to the off (closed) positions before
connecting or disconnecting the HVR to the tank.
CAUTION