Instructions / Assembly
WARNING
• Do not attempt to alter or disconnect the LP cylinder while the appliance is in
use.
• Do not move the LP cylinder while it is connected to the appliance. Always
disconnect to move the appliance and/or tank.
• This appliance is not designed to be connected to a Natural Gas Supply Line.
• The hose and regulator assembly supplied with this appliance must be used.
Approved replacement parts must be obtained from Barbour International,
Inc.
• If the appliance is not in use, the gas must be turned o at the supply LP
cylinder.
• LP cylinders must be stored outdoors out of the reach of children, and shall not
be stored in a building, garage or any other enclosed area.
• Allow only qualied LP gas dealers to properly ll or repair your LP cylinder.
• Always secure the LP cylinder in an upright position.
• Always use the protective cap when not connected to the hose and regulator.
Only use the cap supplied with the LP cylinder; any other type may result in
leakage of propane.
8
THERMOMETER TEST (Check before each use)
TEMPERATURE ACCURACY:
While wearing protective glove, hold the thermometer by the dial and insert stem into boiling water.
The needle should quickly move around the dial and register approximately 212°F (100°C)
(plus or minus 5°F). This indicates whether or not temperature reading is accurate.
NOTE: Due to water evaporation, the maximum reading possible on a thermometer in hot water
is 212°F (100°C).
Replace a faulty thermometer with Model# 5025.
WARNING
• NEVER insert the stem of the thermometer into food. This will cause an incorrect
temperature reading.
• DO NOT attempt to use your thermometer if it is not working.