Instructions / Assembly

7.Attach Hose to Burner – Hold the air shutter up against the end of the burner. Place small end of spring onto tip
of hose, and insert hose into threaded hole at the end of the burner. Tighten the hose into the burner until spring is mostly
compressed and connection is firm. NOTE: the air shutter should be allowed to turn freely, but still hold its position.
6
8.Connect Hose Valve Regulator (HVR) to LP Cylinder –
Check that the LP cylinder is upright and the valve is closed by turning the knob as indicated on the top of the valve until
fully closed. Remove the protective safety cap from the LP cylinder valve and insert the nipple of the large coupling nut into
the cylinder valve outlet (confirm the coupling nut is centered). Turn the large coupling nut clockwise by hand and tighten to
a full stop. Do not cross-thread, and do not use tools.
Upright
position
Hand tighten only