Instructions / Assembly

15
1. Before first use of the appliance, light the cooker and let it run for 5-7 minutes. This initial fire will burn
away the manufacturing oil and residue. It is normal to have smoke or slight odor.
2. Always turn OFF the gas supply and disconnect the hose and regulator from the LP cylinder to move
or store.
4. To prevent rust on a steel cooker, spray the cooked frame with high temperature grill paint or WD-40
on any areas where the paint is chipped or shows signs of wear.
3. If you ever experience a spill over while cooking, make sure you clean off the cooker before storing.
Wait until the cooker is completely cool, and simply spray off the residue from the spill-over. NOTE:
The next time your use the cooker, it may burn off residue from the previous spill-over, causing an odor
and/or smoke.
Follow these simple steps to keep your appliance looking good and functioning properly for years.
NEVER spray anything on a HOT cooker:
• spraying water will give o steam that can cause burns.
• Spray paint and other petroleum distillates can burst into ame.
WARNING
MAINTENANCE & CARE
WARNING
• Do not attempt to adjust or repair the hose and regulator assembly. Contact
Barbour International, Inc. for a replacement.
• Do not attempt to disassemble any part of the hose and regulator assembly.
• The brass valve is NOT and ON/OFF control. It only adjusts the intensity of the
ame. Use the LP cylinder OPD Handwheel to turn o the gas supply.
• Always turn OFF at the LP cylinder OPD Handwheel before attempting to
connect or remove the regulator.
• Never allow the hose to come in contact with sharp edges, or any surfaces
that may become hot during use.
5. The HVR supplied with this kit is an independently
CSA certified product. Read and follow all instructions
and warnings on the supply hose safety tags. If there
is evidence of abrasion, wear, cuts or leaks, the hose
must be replaced prior to the appliance being put into
operation. No matter the physical appearance, replace
the hose and regulator assembly every two years.
Replace only with regulator Model #M5HPR-TMR.
HVR