Specifications

22 CHAPTER 2: FEATURES / SYSTEMS
Ciera 2858 Command Bridge
•
Owner’s Manual
Supplement
Freshwater System
Your boat is equipped with a pressure-demand freshwater (potable)
system. These pressure type (demand) systems operate when the water
pump switch next to the AC panel is in the ON position.
• The water pump’s DC breaker must be turned ON to
use freshwater.
• The water pump’s DC breaker should be turned OFF when any of
the following occurs:
✓ When the boat is not in use.
✓ Whenever the water tank is empty.
• The water tank fill fitting is located on the starboard deck, forward
of the louver (see illustration on the right).
• When your boat is to be left unattended for long periods of time,
pump the water tank dry to prevent stored water from becoming
stagnant and distasteful. Should it become necessary to disinfect
the freshwater system, ask your dealer about treatments available
for your boat’s system.
• Inspect and clean the water filter, located on the water pump, often.
• The water tank is located below the salon floor.
Water Heater
• The water heater is located on the aft port side of the bilge.
• The water heater is connected to the AC power system, therefore,
you must verify that the water heater breaker on the AC panel is
turned ON before water will be heated.
• Read the manufacturer’s instruction manual supplied in your boat’s
owner’s packet and observe the following warnings.
WATER TANK
FILL FITTING
WATER TANK FILL
LOCATION
PUMP
SWITCH
THE AC PANEL IS LOCATED
AC PANEL
12 VOLT
RECEPTACLE
IN THE STARBOARD CABIN
WATER TANK
FILL FITTING
WATER TANK
VENT FITTING
TANK
WATER
WATER PUMP AND WATER
TANK ACCESS THROUGH
WALL AND FLOOR CUTOUTS
PUMP
TANK
FWD
WATER LINE ROUTING
FROM WATER TANK
STBD
WATER
PUMP
WATER LINE
TO GALLEY
WATER LINE
TO HEAD
FITTING FOR
HEATER
WATER
COLD WATER
FITTING FOR
HOT WATER
LINE
LINE