Specifications
Table Of Contents
- Chapter 1: Welcome Aboard!
- Chapter 2: Locations
- Chapter 3: Propulsion & Related Systems
- Chapter 4: Controls & Gauges
- Chapter 5: Navigation & Communication Equipment
- Chapter 6: Plumbing
- Chapter 7: Deck Equipment
- Chapter 8: Appliances & Entertainment Systems
- Chapter 9: Convertible Seats, Beds, & Tables
- Chapter 10: Lights
- Chapter 11: Heating & Air Conditioning
- Chapter 12: Electrical System
- Important Records
- Float Plan

305 • Owner’s Manual Supplement Chapter 12: Electrical System
63
Shore Power
FIRE, EXPLOSION & SHOCK HAZARD!
• Do NOT alter the shore power connectors and use ONLY compatible connectors.
• Turn Off ALL breakers and switches on the 110-volt AC master panel BEFORE plugging in
or unplugging the shore power cord.
• To prevent shock or injury from dropping a 'hot' cord into the water; ALWAYS plug the
shore power cord into the boat inlet first; and then into the dockside outlet.
When unplugging from shore power, ALWAYS unplug the shore power cord from the dock-
side outlet first.
• NEVER leave the shore power cord ONLY plugged into the dockside outlet.
• ONLY use shore power cords approved for marine use. NEVER use ordinary indoor or out-
door extension cords.
DANGER!
!
SHOCK & ELECTRICAL SYSTEM DAMAGE HAZARD!
• Monitor the polarity indicator lights EVERY TIME you connect to shore power.
• If a reversed polarity light turns On when you are connecting to shore power, do NOT turn
On the main breaker switches.
• Instead, IMMEDIATELY unplug the shore power cord (ALWAYS from the dockside outlet
first) and alert marina management.
WARNING!
!
SHOCK & ELECTRICAL SYSTEM DAMAGE HAZARD!
• BEFORE each use, check the shore power cord for defects or damage.
• NEVER use a damaged or faulty cord since the danger of fire and electrical shock exists.
• Do NOT pinch the shore power cord in doors or hatches, or coil the shore power cord too
tightly, since these situations can generate enough heat to result in a fire.
• If a shore power cord is dropped into the water, COMPLETELY dry the blades and contact
slots BEFORE using.
WARNING!
!
ELECTRICAL SYSTEM DAMAGE HAZARD!
• NEVER connect to dockside power outside of North America unless you have the inter-
national electrical conversion option.
• Using several 110-volt AC accessories at the same time can result in an overloaded circuit.
You may have to turn Off one or more accessories to use another accessory.
• Use double insulated or three-wire protected electrical appliances whenever possible.
CAUTION
!










