Specifications

185, 195, 205, & 225 • Owner’s Manual Supplement Chapter 6: Plumbing
51
Livewell System (185, 195 & 205 Only) (If Equipped)
Filling & Using the Livewell
1. Open the intake seacock.
2. Push the livewell switch
to the fill position (for the
location of the livewell
switch, see the Compo-
nent Locations section in
Chapter 2 of this
supplement).
Troubleshooting
If you followed the instruc-
tions in steps 1 and 2 above,
but water does not pump into
the tank, possible causes are:
• The intake seacock is
Closed.
• A hose is collapsed or there
is clogging debris in the
system.
• The livewell fuse is blown.
Draining the Livewell
1. Close the intake seacock.
2. Push the livewell switch
to the drain position.
Aeration Tips
The level of aeration is con-
trolled by the aerator control
valve.
• In clean open water little or
no aeration may be needed.
• In brackish back waters a
higher level of aeration
may be needed.
FLOODING and SWAMPING HAZARD!
• NEVER leave your boat unattended while the livewell system is running.
• Any leak or break in this system may allow large amounts of water to flood the bilge, which
could swamp the battery(s), and even sink your boat.
• Close the intake seacock when leaving your boat unattended for any length of time.
WARNING!
!
SYSTEM DAMAGE HAZARD!
BEFORE turning On the livewell system, make sure the intake seacock is Open.
CAUTION
!