User Guide

1. Turn on the controller.
2. Hold SET for 3 seconds until it shows SV on the top screen. Now the top screen shows the
parameter and the bottom screen shows the parameter value.
3. Press UP or DOWN to adjust the SV value to the desired cut off temperature. (Holding the
button allows for rapid number adjustments.)
4. Press SET to show Hd on the top screen.
5. Press UP or DOWN to adjust the Hd value and create the desired heat on temperature,
remember SV - Hd = HEAT ON TEMPERATURE.
6. Press SET to show Cd on the top screen.
Press UP or DOWN to adjust the Cd value and create the desired cooling on temperature,
remember SV + Cd = COOLING ON TEMPERATURE.
6. Press POWER, congratulations your controller is now programmed!