Installation Instructions

:deriuqer slooT

,erusaem epat ,rab yrp ,remmah ,)nug wercs cirtcele( revird wercS

.sessalg ytefas ,tellam rebbur ,edalb gnittuc latem htoot enif a htiw was retim dnuopmoc

.)dedulcni ton ( swercs llawyrd ro doow "3 :deriuqer slairetam lanoitiddA

.rab yrp dna remmah a htiw dluomkcirB eht evomeR

drawot drawni revoc bmaj ecrof ,ecalp ni revoc bmaj redaeh eht gnidloH

doow eht ot thgit sesserpmoc renroc edisni revoc bmaj eht os ,rood yrtne

swercs daeh nap eht htiw doow gnitsixe ot revoc bmaj redaeh hcattA .bmaj

.sgel gnikcol revoc bmaj neewteb seloh dellird-erp eht hguorht ,dedivorp

GNIDDALC ROOD YRTNE TIF-ORTER

:etoN

.stuc retim eht tuc ot was retim dnuopmoc a gnisu dednemmocer si tI

reporp eht ot stuc retim yrotcaf eht fo eno tuc-eR .otohp eht ni wohs sa uoy

.etalpmet a sa tuc retim yrotcaf eht gnisu htgnel

siht refsnarT .redaeh eht woleb tsuj gninepo rood fo htdiw eht erusaeM

doow a esU .redaeh eht rof revoc bmaj munimula eht ot tnemerusaem

gnicaf eb dluohs revoc bmaj eht no stniop gnikcol owt ehT .was pohc eht fo

deb eht no woleb nwohs sa revoc bmaj eht rednu troppus fo snaem sa kcolb

PAGE 1
RETRO-FIT ENTRY DOOR CLADDING Tools required: Screw driver (electric screw gun), hammer, pry bar, tape measure, compound miter saw with a fine tooth metal cutting blade, rubber mallet, safety glasses. Additional materials required: 3" wood or drywall screws ( not included). Remove the Brickmould with a hammer and pry bar. Measure the width of door opening just below the header. Transfer this measurement to the aluminum jamb cover for the header.
PAGE 2
Measure both the left and the right side verticals from the header jamb cover to the sill. Transfer these dimensions to the face of the vertical aluminum jamb cover. Cut the new sill angle on the bottom of each vertical to match the sill angle on your doors existing sill. Holding the right side aluminum vertical jamb cover in place, force the jamb cover inward toward entry door, so the jamb cover inside corner compresses tight to the wood jamb.
PAGE 3
Align the header brickmould nosing locking legs with header jamb cover locking legs. Miters of both nosing and header jamb cover should be in alignment. Using rubber mallet, tap nosing onto jamb cover locking legs as shown in photo below. Measure from the top of the header brickmould to the bottom of the sill. Transfer that dimension to the vertical brickmould nosing and cut the bottom of the brickmould to the proper length.