Instruction manual

17
Installing the 400-ST1 Cascade Module
The Cascade Module slot on the BayStack 450 switch can
accommodate a single 400-ST1 Cascade Module.
To install a 400-ST1 Cascade Module into the Cascade
Module slot, follow these steps:
1. Unplug the AC power cord from the back of the
switch.
2. Loosen the thumbscrews and remove the filler
panel from the Cascade Module slot (Figure 7
).
Figure 7. Removing the Filler Panel
3. Insert the 400-ST1 Cascade Module into the
chassis slot taking care to slide the module into the
guides provided on the chassis (Figure 8
).
BS0036A
1 = Filler panel
2 = Cascade module slot
1
2