Instruction manual

37
2. Remove the cascade cable from the Cascade A In
connector at unit 5.
3. Remove the units (units 3 and 4) and install
replacement units as required.
4. Renumber the order of the units for the new stack
configuration (if desired).
You can renumber the unit numbers as described in
your switch’s User Guide.
Removing/Replacing Nonadjacent Units
To remove/replace nonadjacent units from an operating
stack, complete the following steps (Figure 17):
1. Remove the cascade cable from the Cascade A In
connector at unit 3.
2. Remove the cascade cable from the Cascade A Out
connector at unit 3.
3. Remove the unit (unit 3) and install the
replacement unit as required.
4. Reconnect the cascade cables (removed in steps 1
and 2) to unit 3.
Note:
Remove and replace the units individually to
avoid segmenting the stack configuration.