Instruction manual

28
Figure 13. Verifying the Installation
• The Base LED for the base unit only is on.
If one (or more) Base LEDs are blinking, no unit (or
more than one unit) is configured as the base unit.
If the LEDs on any of the units in the stack are not as
shown in Figure 13, cycle the power to the stack and verify
the LEDs. Refer to your switch’s User Guide to set up the
stack and for detailed information about stacking,
including troubleshooting.
22 24
21
BayStack
Cas
BS0040B
Cas
Up
Dwn
Base
Pwr
Status
RPSU
1 = Base unit only
2 = All other units in stack
1
2
23
450-24T Switch
Cas
Up
Dwn
Base
Pwr
Status
RPSU