Instruction manual

21
Figure 10. Installing a 400-ST1 Cascade Module
4. Press the module firmly into the chassis slot. Make
sure that the module is fully seated into the mating
connector.
5. Secure the module in the chassis by tightening the
thumb screws on the module front panel.
6. Repeat Steps 1 to 5 for each switch that is to be
configured with the 400-ST1 Cascade Module.
7. Proceed to “Installing and Connecting Multiple
Switches” on page 22.
Cascade A Out
Cascade A In
Unit Select
Base
BS0037A