Instruction manual

19
Installing the 400-ST1 Cascade Module
The Cascade Module slot on supported switches can
accommodate a single 400-ST1 Cascade Module.
To install a 400-ST1 Cascade Module into the Cascade
Module slot, follow these steps:
1. Unplug the AC power cord from the back of the
switch.
2. Remove the filler panel from the Cascade Module
slot (Figures 8 and 9).
•
BayStack 450 and 410-24T
-- Use a
Phillips-head screwdriver to loosen the two
thumbscrews and remove the filler panel
(Figure 8).
Figure 8. BayStack 450/410-24T Filler Panel
1
2
BayStack 410-24T
BayStack 450
1 = Filler panel
2 = Cascade module slot
BS0036B