Specifications

Add a User:

Select A), “Add user,” from the User Management Menu. Enter the name of the user to be added,

followed by <cr>. NOTE: User name is case sensitive.

Assigned Outlets

Select a user number from the User Management Menu, the RPC unit will display the Assign Outlet

Menu:

Figure 6

NOTE: If an outlet user’s list is changed while the user is logged in, their outlet list changes

dynamically. If enabled, an updated outlet status report will be issued. ‘Y’ means the outlet

is assigned to the user. ‘N’ means the outlet is NOT assigned to the user.

Change Outlet Name: Allows the administrator to change the name of the outlets.

Enable/Disable Confirmation: Enables/Disables the confirmation of choices. Example, “Turn off

all outlets [Y/N]?”

Enable/Disable Status Menu: Enables/Disables the status screen. Example, the screen with the

Amperage and Voltage readings is shown when you first log on to the unit.

Change Unit ID: Allows the user to change the name of the unit. The defaulted is something

similar to RPC3ADE-20. Allows the user to personalize or customize name or location, up to 31

alphanumeric characters.

Change Alarm Threshold: The Alarm Threshold is the value set that sounds the amperage alarm

when it reaches or exceeds the amperage value indicated.

Universal Ethernet Controller Configuration:

Newer models of RPC units (with the environmental ports) show a different access menu that the

RPC-NC models

Access Menu:

The Access Menu screen, allows for Outlet Operations, Network Configuration,

or Disconnection. To access the Network Configuration Screen, type five Attention Characters.

-------------------------------------------

| User | Assigned Outlets |

| | 1| 2| 3| 4| 5| 6| 7| 8|

-------------------------------------------

1) engineer | N| N| N| N| N| N| N| N|

-------------------------------------------

1)...Add Outlet(s) Add individual Outlets (X, X, X, X)

2)...Remove Outlet(s) Remove individual Outlets

3)...Add All Outlets Add all outlets to above user

4)...Remove All Outlets Remove all Outlets from the above user

Enter Request: