Specifications

5
QUICK START: Combined RPC Series
by Bay Technical Associates
• Connect the 9FRJ45PC-4 adapter to the user’s computer
• Connect the RPC EIA-232 port to the adapter via the RJ08X007 rolled flat ribbon cable.
• NOTE: The RJ08X007 is NOT an RJ45 network cable.
• Use terminal emulation software to access the unit, 9600 bps, 8 data bits, 1stop bit and no
parity, B/C switch set to ‘B’.
NOTE: At any time during the session you need to go to the Network Access menu, use the
Attention Character = semi-colon (;). Press the attention character key 5 consecutive times to
get back to the Network menu.
NOTE: Password feature is case sensitive. (Default is user/password is root/baytech)
Interior Architecture
Horizontal Units
Vertical Units
Status Screen: Once the serial connection is made using the terminal software, the screen
will display the inherent state of the outlets, the Average Power, RMS voltage, Current and
Maximum Detected Current both in Amps, circuit breaker, Internal temperature of the unit, and
external temperature sensors if connected. The number of outlets displayed depends on the RPC
model.
Power Controller: The power controller
connects to the relay board to control the
outlets. EIA-232 Port maybe on either
controller.
Power Controller: The power controller
connects to the relay board to control the
outlets. EIA-232 located on Controller.