Owner`s manual

RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
59
RPC3 >
“n” refers to selection number, as displayed in Outlet
Status.
LOGOUT : terminate session
OFF n : turn off outlet “n”, do all for n = 0
ON n : turn on outlet “n”, do all for n = 0
REBOOT n : cycle power off/on outlet “n”, do all for n
= 0
RC : display outlet relay control information
STATUS : display power status of outlets
HELP : display this message.
MENU : return to main menu
<Strike CR to continue.>
For units with current monitoring, the
following commands are added:
CLEAR : Reset the maximum detected current
CURRENT : Read the current
The RPC-7 also has internal temperature
monitoring:
TEMP : Read current temperature
CURRENT Some units have current monitoring
MONITORING capabilities. These units monitor the actual
current being drawn by the attached
equipment and the maximum current drawn
since the last initialization. The “CLEAR”
command is used to clear the maximum
current during an operating session. The
“CURRENT” command will read the
measured current at the time the command is
used.
CAUTION: Current measurement circuitry is set at the factory.
Users should not attempt to reinitialize this measurement circuitry.
Any attempt could render the measurements invalid. Contact an
applications engineer if measurements do not appear correct.