Owner`s manual

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

allowing the user to operate the RPC unit.

The password feature is case sensitive.

The factory default outlet names are Outlet

1, Outlet 2, Outlet 3 . . . Outlet 6. From the

RPC’s configuration menu, the user can

change any or all outlet names to outline a

unique set-up.

Change Password From the status menu’s RPC > prompt, type

CONFIG. The following menu appears:

RPC > CONFIG

1) . . . Change Password

2) . . . Change Outlet Name

Enter Request:

Select #1, “Change Password,” and press

<Enter.> The RPC responds:

Enter Current Password:

Since the factory default password is a

carriage return, press <cr>. If this is not an

initial set-up and a password has already

been set, enter the current password,

followed by <cr>. If you enter the password

incorrectly, the RPC responds with an

“Error” message and returns to the main

menu. Consequently, you must start over by

typing “CONFIG” to access the

configuration menu. If you enter the current

password correctly, the RPC responds:

Enter New Password:

Enter a new password (maximum field

length, 8 alphanumeric characters), followed

by <cr>. The RPC responds: