Owner`s manual

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

If you set a password when you were locally

connected to the RPC through the serial

port, the following header appears. Note the

additional prompt for a password:

RPC-2 Series

F2.07

Enter Password:

If prompted, enter password. The following

main menu appears:

RPC-2 Series

F2.07

Circuit Breaker : On

1) . . . OUTLET 1 : Off

2) . . . OUTLET 2 : Off

3) . . . OUTLET 3 : Off

4) . . . OUTLET 4 : Off

5) . . . OUTLET 5 : Off

6) . . . OUTLET 6 : Off

IMPORTANT: When operating remotely, do not send the

command to turn “off” a receptacle that has a host terminal or

modem attached. Doing so will result in the host terminal or

modem being powered down creating a “locked-out” condition.

You will not be able to reestablish a connection until the receptacle

has been turned “on” through the serial port.

CONFIGURATION The RPC-2 MD01’s configuration menu

allows the user to (1) set or change a

password and (2) customize the outlet

name(s) to identify equipment attached to

the RPC.

The password is disabled from the factory

by making the password a carriage return. If

a password (other than a carriage return) is

set, the RPC requires password entry before