Owner`s manual

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

RPC-2 Series

F2.07

Circuit Breaker : On

1) . . . OUTLET 1 : Off

2) . . . OUTLET 2 : Off

3) . . . OUTLET 3 : On

4) . . . OUTLET 4 : Off

5) . . . OUTLET 5 : Off

6) . . . OUTLET 6 : Off

RPC >

Likewise, typing ON 0 at the RPC > prompt

and responding “Y” for yes, turns “On” all

outlets. Typing OFF n at the RPC > prompt

turns off corresponding outlet(s).

The REBOOT n command will reboot or

reset equipment attached to corresponding

receptacle(s). When the command to

REBOOT (n) is sent from the RPC >

prompt, the RPC powers “Off”

corresponding outlet(s) for approximately 10

seconds, then powers them up in sequence.

This command only works on outlets which

were “On” prior to the reboot.

Accessing Main Menu Using communications software, dial the

via Modem modem using the ATDT command. If the

modem does not respond in 5 to 7 rings, the

RPC’s RDR feature recycles power to Outlet

6 and consequently resets the modem. Dial

the modem again using the ATDT

command. When a connection has been

established, the RPC sends the following

header:

RPC-2 Series

F2.07