Owner`s manual

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

Accessing Main Menu Power on the RPC unit. The following

outlet and circuit breaker status menu

appears:

RPC-2 Series

F2.07

Circuit Breaker : On

1) . . . OUTLET 1 : Off

2) . . . OUTLET 2 : Off

3) . . . OUTLET 3 : Off

4) . . . OUTLET 4 : Off

5) . . . OUTLET 5 : Off

6) . . . OUTLET 6 : Off

RPC >

If the status menu fails to appear, ensure the

correct cables and adapters are being used

and that they are connected properly. Also,

verify the serial communication parameters

are correctly configured.

Controlling Receptacles To set or change the status of receptacles,

enter one of the following commands: ON

n, OFF n, REBOOT n, where “n” is the

outlet number you want to command.

Entering an outlet number of “0” sends the

command to all outlets.

Example: To turn “On” Outlet 3, type ON 3 from the

RPC prompt (RPC >). The RPC responds:

Turn On Outlet 3 (Y/N)?

Responding “Y” for yes turns “On” Outlet 3.

Observe that the status of Outlet 3 has

changed to On in the status menu: