Owner`s manual

RPC SERIES OWNER’S MANUAL

DETAILED OPERATION AND CONFIGURATION

________________________________________________________________________________

REMOTE ACCESS Using the RJ04X007 (RJ-11) modular cable,

USING MODEM connect either port labeled “LINE” on the

CONNECTIONS back of the RPC unit to the telco wall jack.

Using the 25MRJ45MD-8 adapter and the

RJ08X007 (8-pin crossed) cable, connect the

DB-25 female port of the modem to the RJ-

45 port labeled “EIA-232” on the back of

the RPC unit.

OPERATION The RPC’s main menu allows you to

monitor and control equipment attached to

each of the RPC-2 MD01’s six receptacles.

From this menu, you can turn on, turn off, or

reboot attached equipment, individually, or

all equipment, simultaneously.

The RPC recognizes three basic operating

commands: ON n<cr>, OFF n<cr>, and

REBOOT n<cr>, where n represents the

outlet number.

There are six red LEDs on the front of the

RPC unit. There is a corresponding red

LED for each of the RPC’s six receptacles.

When the LEDs are illuminated,

corresponding receptacle(s) are turned

"ON," and consequently, attached

equipment is receiving power. If the LED’s

are not illuminated, corresponding

receptacle(s) are turned “OFF.”