Owner`s manual

RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
25
Change Password Select #1, “Change Password,” and press
<cr> The RPC responds:
Enter Current Password:
If this is not an initial set-up and a password
has already been set, enter the current
password, followed by <cr>, otherwise,
press <cr>. If you enter the password
incorrectly, the RPC responds with an
“Error” message and returns to the main
menu. Consequently, you must start over by
typing “CONFIG” to access the
configuration menu. If you enter the current
password correctly, the RPC responds:
Enter New Password:
Enter a new password (maximum field
length, 8 alphanumeric characters), followed
by <cr>. The RPC responds:
Re-Enter New Password:
Re-enter the new password identically to the
first entry. The password feature is case
sensitive. If you fail to re-enter the new
password correctly, the RPC responds with
an “Error” message and returns to the main
menu. Consequently, must start over by
typing CONFIG” from the RPC > prompt to
access the configuration menu. If you re-
enter the new password correctly, the RPC
returns to the main menu again, but you will
not get an “Error” message.
Disabling a Password To disable a password, enter <cr> at the
“Enter New Password” prompt. Enter
<cr> again at the “Re-enter New
Password” prompt. Changing the new