Owner`s manual

RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
21
Using the 9FRJ45PC-1 adapter (or other
applicable adapter) and the RJ08X007
crossed cable, connect the serial port of your
computer to the RJ-45 port labeled “EIA-
232” on the back of your RPC unit.
Load serial port communications software.
Configure host terminal’s serial
communications parameters to match the
RPC. RPC factory serial communications
parameters are 9600 bps, 8 data bits, 1 stop
bit, and no parity.
OPERATION The RPC’s main menu allows the user to
monitor and control the equipment attached
to each of the RPC-2/2A’s six receptacles
and the RPC-4’s eight receptacles. From
this menu, you can turn on, turn off, or
reboot attached equipment, individually, or
all equipment, simultaneously.
The RPC recognizes three basic operating
commands: ON n<cr>, OFF n<cr>, and
REBOOT n<cr>, where n represents the
outlet number and <cr> represents a carriage
return.
There are six red LEDs on the front of the
RPC-2/2A and eight green LEDs on the
front of the RPC-4 unit. There is a
corresponding red or green LED for each of
the RPC’s receptacles. If any or all of the
LEDs are illuminated, corresponding
receptacle(s) are turned "ON," and
consequently, attached equipment is
receiving power. If any or all of the LEDs