Owner`s manual

RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
20
DETAILED OPERATION AND
CONFIGURATION
The following section, “Operation and Configuration,” provides a detailed
approach to accessing, operating, and configuring the RPC.
NOTE: It is important that you type all commands correctly. Any
combination of wrong entries results in an error message. As a
result, you will have to start over from the previous menu.
RPC-2, RPC-2A AND RPC-4
LOCAL ACCESS USING The RPC-2, RPC-2A and RPC-4 have an
THE EIA-232 RJ-45 port for connecting to a local
SERIAL CONNECTION EIA232 device, such as a computer terminal
or external modem. Most serial computers
do not have RJ-45 connections; therefore, an
adapter is provided with this unit to convert
from a DE-9 connector to an RJ-45
connector (BayTech Part No. 9FRJ45PC-1).
If you are connecting to a modem, use a
modem adapter (BayTech Part No.
25MRJ45MD-8).
BayTech also manufactures a
computer/terminal adapter (BayTech Part
No. 25FRJ45PC-1) for converting from a
DB-25 connector to a RJ-45 connector.
If your computer does have an RJ-45
connection, but the pin signals are different
from those described for BayTech on Page
17 of this manual, it is possible for BayTech
to customize an adapter for you. If you
require a different adapter than the one
supplied with this unit, contact BayTech’s
Applications Engineers.