Owner`s manual

RPC SERIES OWNER’S MANUAL

RPC SERIES QUICK START (RPC3-15/20, RPC-3A, RPC-5, RPC-7 AND RPC-21)

________________________________________________________________________________

Change Password Default password is <cr>; disabled.

Password is case sensitive.

Change Outlet From the User Management Menu, select

List the number of the user to modify, followed

by <cr>. Enter the number of the outlet(s) to

which you want to give or remove access. If

there is more than one outlet, enter the

numbers, separated by commas. Example:

2,6,8. Default is no outlets selected.

CONFIGURATION

IMPORTANT: For network access, you must configure the IP

address, subnet mask, and gateway from the serial port.

NOTE: Network parameters, such as IP Address, require a unit

reset.

IP Address Enter the RPC unit’s IP address in dotted

decimal format (200.4.3.50). Default is

0.0.0.0

Subnet Mask Enter the RPC unit’s subnet mask in dotted

decimal format (255.255.255.0). Default is

0.0.0.0

Gateway Enter the RPC unit’s Gateway address in

dotted decimal format (200.4.5.50). Default

is 0.0.0.0

Unit ID Enter the RPC unit’s Unit ID (64 chars

max). Default is unit dependent