Owner`s manual

RPC SERIES OWNER’S MANUAL

RPC SERIES QUICK START (RPC-2 MD01)

________________________________________________________________________________

OPERATION

Accessing Main Menu Power on the RPC unit. The following

status menu appears:

RPC-2 Series

F2.07

Circuit Breaker : On

1) . . . OUTLET 1 : Off

2) . . . OUTLET 2 : Off

3) . . . OUTLET 3 : Off

4) . . . OUTLET 4 : Off

5) . . . OUTLET 5 : Off

6) . . . OUTLET 6 : Off

RPC >

If the status menu fails to appear, ensure

the correct cables and adapters are being

used and that they are connected properly.

Also, verify the serial communication

parameters are correctly configured.

Controlling Receptacles To set or change the status of the

receptacles, enter one of the following

commands: ON n, OFF n, REBOOT n,

where “n” is the outlet number you want to

command. Entering an outlet number of

“0” sends the command to all outlets.

Reboot only works on outlets that are in the

“ON” condition.

CONFIGURATION Type “CONFIG” from the RPC>prompt.

The following menu appears:

RPC >CONFIG

1) . . . Change Password

2) . . . Change Outlet Name

Enter Request: