Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

Enter Unit Number (1-32) <cr>, or X to EXIT:

Enter Module Number (1-16) <cr>, or X to EXIT:

Enter Port Number (1-4) <cr>, or X to EXIT:

Enter the appropriate Host Address. This consists of the Unit Number (1 to 32),

Module Number (1 to 16), and Port Number (1 to 4) where the designated host

module is located. Each entry should be followed by <cr>. If there is a single M

Series unit in service, the Host Address would typically be Unit 1, Module 1, Port 1.

NOTE: The Host Address must be supplied to direct self-reporting data

messages to the desired destination. If the Host Address is incorrect, self-

reporting data messages will be misdirected or lost.

TIME TAG

Type “5” (in the reporting setup menu) and <cr> to enable or disable the time tag. The

module will respond:

ENABLE / DISABLE TIME TAGGING

Time Tagging DISABLED

Enable 1

Disable 2

Exit X

Enter Selection:

With time tag enabled, a MM/DD/YY HH/MM/SS entry is appended to all samples,

where MM is the month, DD is the day, YY is the year, HH is the hour, MM is the

minute, and SS is the second according to the base unit's time-of-day clock.

TERMINATING CHARACTER(S)

Type “6” (in the reporting setup menu) and <cr> to change the terminating

character(s). The module will respond:

ENTER TERMINATING CHARACTER

Terminating Character(s) 0D0A

Enter 1 or 2 Terminating Characters in Hex Format

(i.e. 0D0A for CR+LF) <cr>, or X to Exit: