Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

Enter the desired Report Start Time. For example, suppose the Current Time is

9:20:30 and the Reporting Start Time is set to 10:45. After you exit the Configuration

Main Menu, the V78 CRM-1 will start reporting data messages at 10:45 at the

programmed Sampling Setup. If the M Series loses power, reporting resumes the

next time the designated Report Start Time is observed by the time-of day clock.

IMPORTANT: The Current Date04/28/00 and Time is not updated during

data entry. You must consider any delays from the time you enter the Report

Start Time until you exit the Configuration Main Menu. Be sure to set the

Report Start Time far enough ahead of the current time to complete all

configurations and exit configuration mode.

NOTE: When using Schedule Reporting Method and the V78 CRM-1 is

initially reporting, if you enter into the menu-driven mode of configuration

and exit, the V78 CRM-1 will not resume reporting data messages until the

programmed Report Start Time elapses. You may program the CRM-1

without disrupting data message reporting by using dynamic configuration.

REPORT INTERVAL

Type “3” (in the reporting setup menu) and <cr> to change the reporting interval. The

module will respond:

REPORT INTERVAL

Report Interval HH:MM

Enter Hours (0-24) <cr>, or X to Exit:

Enter Minutes (0-59) <cr>, or X to Exit:

Enter the desired Report Interval. The Report Interval can range from 1 minute to 24

hours. Once the Report Start Time elapses, the V78 CRM-1 will report all buffered

data messages to the designated host module until the buffer is empty. The V78

CRM-1 will continue to transmit all buffered data messages every time the Report

Interval expires. For example, if the Report Start Time is 12:00 and the Report

Interval is 1:00 (1 hour), the V78 CRM-1 will report all messages in its buffer every

hour on the hour starting at 12:00.

HOST ADDRESS

Type “4” (in the reporting setup menu) and <cr> to change the host address. The

module will respond:

HOST ADDRESS

Host Address 1:1,1