Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
83
EVENT DURATION
Event Duration.......................00:00
Select Duration in (H)ours and Minutes or (M)illiseconds
(H/M), or X to EXIT:
Type "H" to program the Event Duration in Hours and Minutes or "M" for
milliseconds. For example, if you type "M" for milliseconds, the CRM-1 will
respond with:
Enter Duration (10-60000 Milliseconds)<cr>, or X to EXIT:
Type the desired number of milliseconds you want the selected relay to remain
energized followed <cr>.
The CRM-1 will prompt you to enter the desired relay number that you wish the
selected event to energize. The CRM-1 will respond with:
Enter Relay Number (1-8)<cr>, or X to EXIT:
Type the desired relay number (1 to 8) followed by <cr>. The CRM-1 will respond
with:
DATA CORRECT (Y/N)?
If the data displayed for the selected Event Number is correct type "Y". The CRM-1
will return to the Relay Operating Setup menu shown on page 16. If you type "N",
the CRM-1 will return to the Event Start Time menu shown on the previous page.
ENABLE/DISABLE EVENTS
Type “3” (in the relay operating setup menu) and <cr> to enable or disable events.
The module will respond:
ENABLE/DISABLE EVENTS
Event Number(s) 0 ENABLED
Enter Event Number (1-12, 0=ALL)<cr>, or X to exit:
This menu shows the current Event Numbers enabled and prompts you to type the
desired Event Number to enable or disable followed by <cr>. Enter the desired Event
Number to enable or disable. The V78 CRM-1 will respond with:
Enable 1
Disable 2
Exit X