Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

V78 CRM-1 MODULE CONFIGURATION

To access configuration mode of the V78 CRM-1, use the procedures on page 44.

CONFIGURATION MAIN MENU

With $CONFIG input the V78 CRM-1 module installed as Module X will respond

with an identification block and a menu of the available configuration options similar

to the following:

DAC V78 CRM-1 Rev. 1.01

This Module is X

CONFIGURATION MAIN MENU

Module Status 1

Relay Operating Setup 2

Reporting Setup 3

Dynamic Configuration 4

Exit X

Enter Selection:

NOTE: The configuration menus shown in the following sections are

depicted with factory default settings and may vary slightly in presentation.

Enter the number corresponding to your desired choice. Each choice will invoke a

sub-menu. Each sub-menu is described in the following sections. When you exit a

sub-menu, you will be returned to the configuration main menu. When "Exit" is

selected from the main menu, the V78 CRM-1 will exit from configuration mode and

go into an active data collection mode.

MODULE STATUS

Type “1” (in the configuration main menu) and <cr> to display module status. The

module will respond:

MODULE STATUS

Schedule Status NO SCHEDULE ENTERED

Reporting Method COMMAND

Reporting Start Time 24:00

Reporting Period 24:00