Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
69
Enter the desired Sample Interval. Enter 00:00:00 for continuous sampling.
Continuous sampling is conducted at the programmed Sample Rate and Number of
Samples to Average.
If a Sample Interval is entered, repetitive sampling will occur where the V77 ADM-1
will sample for a specified period of time and then stop sampling for a specified time
interval. Sample Interval is the time interval between the start of sampling periods.
The length of time of sampling periods is determined by the Sampling Rate and the
Number of Samples to Average.
SAMPLE RATE
Type “4” and <cr> to enter the Sample Rate menu. The V77 ADM-1 will respond:
SAMPLE RATE
Sample Rate 1S/sec
Enter Rate (1-4000S/sec) <cr>, or X to Exit:
Samples rates between 1 and 4000 samples/sec can be selected. The programmed
Sample Rate is the sample rate for individual channels. The maximum sample rate
for an individual channel is 4000 divided the number of active channels. For
example, if there are eight active channels, the maximum individual channel sample
rate is 500S/sec.
The maximum sample rate, based on the number of active channels selected, is
calculated automatically. If you try to exceed the maximum individual channel
sample rate, your entry is ignored and the correct maximum rate displayed.
NOTE: The number "4000" in the above menu is automatically reduced to
the maximum individual channel sample rate based upon the number of
active channels.
NUMBER OF SAMPLES TO AVERAGE
Type “5” and <cr> to enter the Samples To Average menu. The V77 ADM-1 will
respond:
NUMBER OF SAMPLES TO AVERAGE
No. of Samples to Average..........10
Enter Samples (1-4000) <cr>, or X to Exit:
Enter the desired Number of Samples to Average.