Owner`s manual
M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
68
SAMPLING START TIME
Sampling Start Time HH:MM
Current Date04/28/00 and Time MM/DD/YY HH:MM:SS
Enter Hours (0-24) <cr>, or X to Exit:
Enter Minutes (0-59) <cr>, or X to Exit:
This menu shows the current Sample Start Time, the base unit's current date and time,
and prompts you to enter the desired Sampling Start Time. Sampling can be delayed
up to 24 hours from the current time. The Current Date04/28/00 and Time are the
values reported by the base unit's time-of day clock when the reporting start time
entry was selected.
IMPORTANT: The Current Date04/28/00 and Time is not updated during
data entry. Therefore, you must consider any delays from the time you enter
the Sample Start Time until you exit the Configuration Main Menu. Be sure
to set the Sample Start Time late enough to complete all configurations and
exit the Configuration Main Menu before the designated Sample Start Time.
If you set a Sample Start Time and exit the main configuration menu after
the designated Sample Start Time elapses, sampling will be delayed until the
following day.
Enter the desired Sample Start Time. For example, suppose the current time is
9:20:30 and the Sample Start Time is set to 10:45. After you exit the Configuration
Main Menu, the V77 ADM-1 will start sampling data at 10:45 the programmed
Sampling Setup. If the M Series loses power, sampling resumes the next time the
designated Sample Start Time is observed by the time-of day clock. If, for example,
power is removed at 11:30 and restored at 12:00 and the Sample Start Time is set to
10:45, sampling will resume at 10:45 the following day.
SAMPLE INTERVAL
Type “3” and <cr> to enter the Sample Interval menu. The V77 ADM-1 will respond:
SAMPLE INTERVAL
Sample Period HH:MM:SS or "CONTINUOUS"
NOTE Enter 00:00:00 for continuous sampling.
Enter Hours (0-24) <cr>, or X to Exit:
Enter Minutes (0-59) <cr>, or X to Exit:
Enter Seconds (0-59) <cr>, or X to Exit: