Owner`s manual

M SERIES DAC
BASE UNIT AND MODULE CONFIGURATION
____________________________________________________________________________
66
Sampling Method COMMAND
Sample Start Time HH:MM
Sample Period HH:MM:SS
Sample Rate 1S/sec
No. of Samples to Average 10
Reporting Method COMMAND
Reporting Start Time 24:00
Reporting Period 24:00
Host Address 1:1,1
Data Format HEX
Time Tagging DISABLED
Terminating Characters 0D0A
Press a key to continue or X to Exit...
Range +/-5 or 0-10 Volts
Unipolar / Bipolar BI
Single Ended / Differential SE
Active Channels 1000000000000000
Dynamic Configuration DISABLED
Press any key t o Exit
SAMPLING SETUP
Type “2” and <cr> to enter the Sampling Setup menu. The V77 ADM-1 will respond:
Sampling Method 1
Sample Start Time 2
Sample Interval 3
Sample Rate 4
No. of Samples to Average 5
Exit X
Enter Selection:
The three Sampling Methods are Command (upon request only), Immediate (upon
exiting configuration), and Schedule (where sampling begins at the Sample Start
Time). Sample Interval is the interval between the start of sampling periods.
Continuous sampling is selected if 00:00:00 is entered. Sample Rate can be
programmed from 1 to 4000 samples per second. The sample rate for an individual
channel is the programmed rate divided by the number of active channels. Number of
Samples to Average is the number of samples averaged per data message.
SAMPLING METHOD
Type “1” and <cr> to enter the Sampling Method menu. The V77 ADM-1will
respond: