Owner`s manual

M SERIES DAC

BASE UNIT AND MODULE CONFIGURATION

____________________________________________________________________________

MAIN MENU CONFIGURATION

To access the menu-driven configuration mode of the V77 ADM-1 from any host

module, use the procedure on page 44.

With $CONFIG input the V77 ADM-1 installed as Module X will respond with an

identification block and a menu of the available configuration options similar to the

following:

DAC V77 ADM-1 Rev. 1.##

This Module is X

CONFIGURATION MAIN MENU

Module Status 1

Sampling Setup 2

Reporting Setup 3

Channel Input Setup 4

Dynamic Configuration 5

Exit X

Enter Selection:

NOTE: The configuration menus shown in the following sections are

depicted with factory default settings and may vary slightly in presentation.

Enter the number corresponding to your desired choice. Each choice will invoke a

sub-menu. Each sub-menu is described in the following sections. When you exit a

sub-menu, you will be returned to the configuration main menu. When "Exit" is

selected from the main menu, the V77 ADM-1 will exit from configuration mode and

go into an active data collection mode.

MODULE STATUS

Type “1” and <cr> to enter the Module Status menu. The V77 ADM-1 will respond:

MODULE STATUS